Wedding and evening dresses with a U-shaped back

The U-contour does not have a sharp top: its lower part turns into a smooth rounded arc. It is the continuous curve that defines the U-shaped back, and its beginning can be located at the shoulders or below. The depth is measured by the position of the center of the arch, but the shape itself does not tell how open the entire rear area will be.

V-back has two distinct edges converging to a lower point, while the U goes around the center without an acute angle. Low Back describes the depth, a open — the area of ​​the visually unclosed part. The U-bend is often combined with them in the catalog, but each characteristic must be defined separately.

Ask to see if the center of the arch coincides with the axis of the clasp and back. Next, compare the right and left side points: they should start at the intended height, and the curve should go between them without accidental breaks. If the edge is decorated beads, trace the rhythm of the decoration on both sides and its completion near the center. The decor itself should not replace the assessment of the constructive line.

Raise your hands, sit down, turn your body to the right and left, then stand straight again. Take a shot straight from the back and one from each diagonal angle. Compare the center, side height, clasp and pattern before and after the movement. On fitting at CRYSTAL, this sequence shows the actual geometry without promises of softness, stretch, support or compatibility with certain underwear.